![]() And make sure you mark TOP at the top of both sides. You’ll have to flip your half template to make sure the holes are exactly level from front to back so you’ll need to mark the Font and Back of this template. It’s easiest to cut a piece that will span the full depth of your cabinet but if you have a scrap of pegboard that is tall enough and don’t want to purchase a whole new sheet you can make it work. If you are drilling your shelf pin holes after cabinet assembly, youy jig will have to fit inside the cabinet. *Most importantly, write TOP at the top of your template! If pre-drilling before cabinet assembly, also write TOP on the top of your cabinet sides so you assemble your cabinet correctly. ![]() ![]() Circle the holes you will drill with a big, bold marker! Pegboard holes are very close together so skip every other one.Shelf pin holes should be 1 1/2″ – 2″ from the outside edge of the cabinet sides.Start and stop holes 6-8″ from top and bottom of any fixed shelf and cabinet top and bottom.Mark location of any FIXED shelves that will be permanently attached to cabinet sides.There is no need to drill holes all the way from top to bottom.You can cut your shelf drilling jig the same size as your cabinet sides, mark and drill all your shelf pin holes before you even assemble or drill them after assembly.Įither way MARK your shelf drilling jig with a permanent marker so you know exactly where to drill your holes and they all end up in exactly the same location. Maryville TN House Tour – Completed Rooms.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |